Compressor
- RotorComp NK100 single stage Screw
- 40 HP Frame
- Suction Pressure up to 10psi
- Discharge Pressure up to 150psi
- Integrated Oil Sump
Driver
- Teco Westinghouse 40 Hp
- 230/460 Vac, 3Phase, 60 Hz
- 1800 RPM
- 324T, TEXP
Vessels and Piping
- 12” x 48” Inlet Scrubber
- 8” x 48” Discharge Scrubber
- 4” x 42” Gas Drying Vessels (x2)
- CRN Registered Vessels
- ASME B31.3 Pressure Piping
Skid and Building
- 8’ x 10’ Structural Skid
- 8’ x 10’ x 9’ SIM Panel Building
- Single Man door with window
- Manual Intake/Exhaust louvers
- 24” x 24” Catalytic, Natural Gas Heater
Typical Controls
- Prologic PLC
- Pressure and Temperature Shut-down Transmitters
- Oil Thermostatic Control Valve
- Roots Flow Meter
Misc.
- Gas/Oil After Cooler, 1Hp Motor
- Bruin, Liquid Pump
- Low Suction Recycle Regulator
- Class 1 Div. 2 Rated
Typical Applications
- Heavy Oil “Vent” Gas Recovery Fuel Gas Compression
- Sell Excess Dry “Spec” Gas Off-Site
- Reduce or Eliminate On-Site Propane or Fuel Gas Costs
- Achieve Environmental Compliance
Installation Requirements
Inlet Connection 2” NPT
Outlet Connection 1” NPT
On-Site Fuel Gas Connection 1” NPT
Drain Connection 1” NPT
PSV Header Connection 2” NPT
Drain Connection 1” NPT
Shipping Weight 7000 lbs
Lifting
The compressor package must be lifted and placed using a proper lifting device, consisting of a four-point lift (from each corner of the package). The package must remain level during lifting and placement. The unit cannot be skidded and dropped.
General Performance – Dry “Spec” Gas Output