Compressor
- RotorComp NK60 single stage Screw
- 20 HP Frame
- Suction Pressure up to 15 psi(103kPa)
- Discharge Pressure up to 200psi (1379kPa)
- Integrated Oil Sump
Driver
- Hydraulic Motor
- 6 cm³/rev
- 300 – 3000 rpm
Vessels and Piping
- 8” x 48” Inlet Scrubber
- 4” x 42” Discharge Scrubber
- 4” x 42” Gas Drying Vessels (x2)
- CRN Registered Vessels
- ASME B31.3 Pressure Piping
Skid and Building
- 8’ x 8’ Structural Skid
- 8’ x 8’ x 8’6” SIM Panel Building
- Double access Door
- Manual Intake/Exhaust louvers
- 12” x 24” Catalytic, Natural Gas Heater
Typical Controls
- Prologic PLC
- Pressure and Temperature Shut-down Switches
- Oil Thermostatic Control Valve
Misc.
- Gas/Oil After Cooler
- Low Suction Recycle Regulator
- Class 1 Div. 2 Rated
Typical Applications
- Casing Gas Compression
- Fuel Gas Compression
- Blanket Gas Compression
- Sell Excess Dry “Spec” Gas Off-Site
Installation Requirements
Inlet Connection 2” NPT
Outlet Connection 1” NPT
On-Site Fuel Gas Connection 1” NPT
Drain Connection 1” NPT
PSV Header Connection 2” NPT
Drain Connection 1” NPT
Shipping Weight 7000 lbs
Lifting
The compressor package must be lifted and placed using a proper lifting device, consisting of a four-point lift (from each corner of the package). The package must remain level during lifting and placement. The unit cannot be skidded and dropped.
General Performance – Dry “Spec” Gas Output