Compressor
- RotorComp NK60 single stage Screw
- 20 HP Frame
- Suction Pressure up to 15 psi(103kPa)
- Discharge Pressure up to 200psi (1379kPa)
- Integrated Oil Sump
Driver
- Teco Westinghouse 15 Hp
- 230/460 Vac, 3Phase, 60 Hz
- 3600 RPM
- 254T, TEXP
Vessels and Piping
- 8” x 48” Inlet Scrubber
- 4” x 42” Discharge Scrubber
- 4” x 42” Gas Drying Vessels (x2)
- CRN Registered Vessels
- ASME B31.3 Pressure Piping
Skid and Building
- 6’ x 4’ Structural Skid
- 6’ x 4’ x 7’ SIM Panel Building
- Single Man door with window
- Manual Intake/Exhaust louvers
- 12” x 24” Catalytic, Natural Gas Heater
Typical Controls
- Prologic PLC
- Pressure and Temperature Shut-down Switches
- Oil Thermostatic Control Valve
Misc.
- Gas/Oil After Cooler
- Low Suction Recycle Regulator
- Class 1 Div. 2 Rated
Typical Applications
- Casing Gas Compression
- Fuel Gas Compression
- Blanket Gas Compression
Installation Requirements
Inlet Connection 2” NPT
Outlet Connection 1” NPT
Wellhead Connection Either hard pipe or flexible hose may be used
Shipping Weight 9000 lbs
Lifting
The compressor package must be lifted and placed using a proper lifting device, consisting of a four-point lift (from each corner of the package). The package must remain level during lifting and placement. The unit cannot be skidded and dropped.